Installation [02/2014 - 11/2016]: Procedure

INSTALL BACK DOOR GLASS GUIDE UPPER BRACKET LH
Refer to PROCEDURE - Step 2
INSTALL BACK DOOR GLASS GUIDE UPPER BRACKET RH
HINT:

Use the same procedure as for the LH side.
INSTALL BACK WINDOW LOCK STRIKER ASSEMBLY
1. Install the back window lock striker assembly with the 2 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)

INSTALL BACK WINDOW MOULDING OUTSIDE LH

Clean the back door glass.
Remove the release paper from a new back window moulding outside LH.
HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.

Install the new back window moulding outside LH as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard Dimension

Area	Dimension
a	5.0 mm (0.197 in.)
b	5.0 mm (0.197 in.)

INSTALL BACK WINDOW MOULDING OUTSIDE
HINT:

Use the same procedure as for the back window moulding outside LH.
INSTALL BACK DOOR GLASS
1. Install the back door glass with the 4 nuts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
INSTALL BACK WINDOW STAY ASSEMBLY LH
Refer to PROCEDURE - Step 4
INSTALL BACK WINDOW STAY ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.
INSTALL REAR SPOILER ASSEMBLY
Refer to INSTALLATION [02/2014 - 11/2016]
INSTALL REAR WIPER MOTOR
Refer to INSTALLATION [02/2014 - 11/2016]