Inspection [02/2014 - ]: Procedure
- INSPECT SEAT HEATER ASSEMBLY (REAR LH SIDE SEATBACK)
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Seat Heater Assembly (Rear LH Side Seatback))Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Always 4.36 Ω If the result is not as specified, replace the seat heater assembly (rear LH side seatback).
- Measure the resistance according to the value(s) in the table below.
- INSPECT SEAT HEATER ASSEMBLY (REAR RH SIDE SEATBACK)
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Seat Heater Assembly (Rear RH Side Seatback))Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Always 4.36 Ω If the result is not as specified, replace the seat heater assembly (rear RH side seatback).
- Measure the resistance according to the value(s) in the table below.