Removal [02/2014 - 11/2016]: Procedure

REMOVE REAR SIDE SPOILER SUB-ASSEMBLY LH

Remove the 2 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 3 claws to remove the rear side spoiler sub-assembly LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE REAR SIDE SPOILER SUB-ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.

REMOVE REAR SPOILER SUB-ASSEMBLY

Apply protective tape around the rear spoiler sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Disconnect the wire harness.

NOTE:

Do not allow the disconnected wire harness to get caught between the back door and vehicle body to prevent it from being damaged.

Turn back the wire harness grommet.

Disengage the 4 claws and pull out the wire harness from the vehicle body.

NOTE:

Do not forcibly pull the wire harness.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the rear washer hose.

Disengage the grommet.

Disconnect the connector.

Remove the 6 bolts.

Disengage the 2 claws.

Raise and lower the glass hatch and the back door respectively. Pull out the wire harness from the vehicle body and remove the rear spoiler sub-assembly.