LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Service Information) (Hybrid) (1 Of 2) >> Power Back Door Drive Unit >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

  1. REMOVE BACK WINDOW UPPER TRIM PANEL 

    See step  1

  2. REMOVE BACK DOOR TRIM COVER LH 

    See step  2

  3. REMOVE BACK DOOR TRIM COVER RH 

    HINT: 

    Use the same procedure as for the LH side.

  4. REMOVE BACK DOOR LOCK COVER 

    See step  4

  5. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER 

    See step  5

  6. REMOVE NO. 1 BACK DOOR SERVICE HOLE COVER 

    See step  6

  7. REMOVE BACK DOOR TRIM PANEL ASSEMBLY 

    See step  7

  8. REMOVE POWER BACK DOOR UNIT SET ASSEMBLY 
    NOTE:
    • Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.
    • Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.
    1. Disconnect the connector.
      GTY447812Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Grommet
    2. Disengage the grommet.
    3. Remove the 4 bolts and power back door unit set assembly.
      GTY435538Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Remove the power back door unit set assembly while supporting the back door by hand.

scientia non olet · About LEMON Manuals