Buzzer does not Sound [11/2016 - ]: Procedure

1. Check that the rear cross traffic alert buzzer (blind spot monitor buzzer) sounds when the initial check is performed.

   Refer to SYSTEM DESCRIPTION [11/2016 - ]

   OK

   Rear cross traffic alert buzzer sounds

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to  REMOVAL [11/2016 - ] 

Result:  2

NG 

See step  2

1. Turn the power switch off.
2. Turn the power switch on (IG).
3. Recheck for DTCs and check if the same DTC is output again.

   Body Electrical > Blind Spot Monitor Slave > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2016 - ] 

Result:  1

OK 

See step  3

1. Disconnect the M20 rear cross traffic alert buzzer (blind spot monitor buzzer) connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   M20-1 (BZP) - Body ground	Power switch on (IG)	11 to 14 V
   M20-2 (BZN) - Body ground		Below 1 V
   M20-2 (BZN) - M20-1 (BZP)		Below 1 V

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result:  1

OK 

See step  4

1. Disconnect the M20 rear cross traffic alert buzzer (blind spot monitor buzzer) connector.
2. Disconnect the L23 blind spot monitor sensor RH connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   M20-2 (BZN) - L23-3 (BUZ)	Always	Below 1 Ω
   M20-2 (BZN) or L23-3 (BUZ) - Body ground	Always	10 kΩ or higher

4. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   M20-2 (BZN) or L23-3 (BUZ) - Body ground	Power switch on (IG)	Below 1 V
   M20-1 (BZP) - Body ground	Power switch on (IG)	11 to 14 V
   M20-1 (BZP) - Body ground	Power Switch off	Below 1 V

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE BLIND SPOT MONITOR BUZZER. Refer to  REMOVAL [02/2014 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR