DTC C1AC2: Slave Module Horizontal Axis Misalignment [02/2014 - 11/2016]: Procedure

1. Check the installation condition of the blind spot monitor sensor RH.

   Refer to OPERATION CHECK [02/2014 - 11/2016]

   HINT: 

   Take the appropriate action in accordance with the result.

Result: 

NEXT 

1. Install the rear bumper.

   Refer to INSTALLATION [02/2014 - ]

2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream.

   Refer to OPERATION CHECK [02/2014 - 11/2016]

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

END 

Result:  2

NG 

REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to  REMOVAL [02/2014 - 11/2016]