DTC B1585: USB Device Malfunction [02/2014 - ]: Procedure

REPLACE USB DEVICE OR "iPod"
1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
2. Turn the power switch off.
  HINT:
  
  When this DTC has been stored, it is necessary to turn the power switch to off make it possible for the vehicle to recognize a new device when it is connected.
3. Turn the power switch on (ACC).
4. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
  HINT:
  - If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
  - Refer to System Description for compatible formats and versions.
    Refer to SYSTEM DESCRIPTION [02/2014 - 11/2015] Refer to SYSTEM DESCRIPTION [11/2015 - 11/2016] Refer to SYSTEM DESCRIPTION [11/2016 - ]
NEXT

CHECK DTC

Clear the DTCs.
Refer to DTC CHECK / CLEAR [02/2014 - 11/2015] Refer to DTC CHECK / CLEAR [11/2015 - 11/2016] Refer to DTC CHECK / CLEAR [11/2016 - ]

Body Electrical > Navigation System > Clear DTCs

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK

No DTCs are output.

Result

Proceed to
OK
NG

Result: 1

OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE

Result: 2

NG

REPLACE NAVIGATION RECEIVER ASSEMBLY. Refer to REMOVAL [02/2014 - ]