Inspection [11/2016 - ]: Procedure
- INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 6 Speakers)
- With the speaker installed, check that there is no looseness or other abnormalities.
- Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
- Measure the resistance of the speaker.
*a Component without harness connected
(Front No. 2 Speaker Assembly)Standard Resistance
Tester Connection Condition Specified Condition 4 - 2 Always 10 kΩ or higher 3 - 4 Always Below 1 Ω 1 - 2 Always Below 1 Ω If the result is not as specified, replace the speaker.
- When there is a possibility that either the right or left speaker is malfunctioning, interchange the speakers and perform an inspection. If the malfunction disappears after interchanging the speakers, replace the malfunctioning speaker.
HINT:
Connect all connectors to the speakers when performing an inspection. If the result is not as specified, replace the speaker.
- INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 12 Speakers)
- With the speaker installed, check that there is no looseness or other abnormalities.
- Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
- When there is a possibility that either the right or left speaker is malfunctioning, interchange the speakers and perform an inspection. If the malfunction disappears after interchanging the speakers, replace the malfunctioning speaker.
HINT:
Connect all connectors to the speakers when performing an inspection. If the result is not as specified, replace the speaker.
- INSPECT FRONT NO. 3 SPEAKER ASSEMBLY (for 12 Speakers)
- With the speaker installed, check that there is no looseness or other abnormalities.
- Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
- Measure the resistance of the speaker.
*a Component without harness connected
(Front No. 3 Speaker Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Always 6.8 to 10.2 Ω If the result is not as specified, replace the speaker.