Inspection [02/2014 - ]: Procedure
- INSPECT REAR NO. 2 SPEAKER ASSEMBLY (for 12 Speakers)
- With the speaker installed, check that there is no looseness or other abnormalities.
- Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
- Measure the resistance of the speaker.
*a Component without harness connected
(Rear No. 2 Speaker Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 (WF2-) - 2 (WF2+) Always 4.8 to 6.8 Ω 3 (WF1-) - 4 (WF1+) Always 4.8 to 6.8 Ω If the result is not as specified, replace the speaker.
- INSPECT REAR NO. 3 SPEAKER ASSEMBLY (for 12 Speakers)
- With the speaker installed, check that there is no looseness or other abnormalities.
- Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
- Measure the resistance of the speaker.
*a Component without harness connected
(Rear No. 3 Speaker Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Always 6.8 to 10.2 Ω If the result is not as specified, replace the speaker.