Inspection [11/2016 - ]: Procedure
- INSPECT REAR LIGHT ASSEMBLY LH
*a Component without harness connected
(Rear Light Assembly LH)- Apply auxiliary battery voltage to the rear light assembly LH and check that the lights illuminate.
OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 3Taillight illuminates Auxiliary battery positive (+) → Terminal 2
Auxiliary battery negative (-) → Terminal 3Stop light illuminates If the result is not as specified, replace the rear light assembly LH or rear light socket and wire LH.
- Apply auxiliary battery voltage to the rear light assembly LH and check that the lights illuminate.
- INSPECT REAR LIGHT ASSEMBLY RH
*a Component without harness connected
(Rear Light Assembly RH)- Apply auxiliary battery voltage to the rear light assembly RH and check that the lights illuminate.
OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 3Taillight illuminates Auxiliary battery positive (+) → Terminal 2
Auxiliary battery negative (-) → Terminal 3Stop light illuminates If the result is not as specified, replace the rear light assembly RH or rear light socket and wire RH.
- Apply auxiliary battery voltage to the rear light assembly RH and check that the lights illuminate.