Inspection [11/2016 - ]: Procedure
- INSPECT REAR COMBINATION LIGHT ASSEMBLY LH
*a Component without harness connected
(Rear Combination Light Assembly LH)- Apply auxiliary battery voltage to the rear combination light assembly LH and check that the lights illuminate.
OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 5Stop light illuminates Auxiliary battery positive (+) → Terminal 4
Auxiliary battery negative (-) → Terminal 5Taillight and rear side marker light illuminates If the result is not as specified, replace the rear combination light assembly LH.
- Apply auxiliary battery voltage to the rear combination light assembly LH and check that the lights illuminate.
- INSPECT REAR COMBINATION LIGHT ASSEMBLY RH
*a Component without harness connected
(Rear Combination Light Assembly RH)- Apply auxiliary battery voltage to the rear combination light assembly RH and check that the lights illuminate.
OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 5Stop light illuminates Auxiliary battery positive (+) → Terminal 4
Auxiliary battery negative (-) → Terminal 5Taillight and rear side marker light illuminates If the result is not as specified, replace the rear combination light assembly RH.
- Apply auxiliary battery voltage to the rear combination light assembly RH and check that the lights illuminate.