Inspection [02/2014 - 11/2016]: Procedure

INSPECT REAR COMBINATION LIGHT ASSEMBLY LH

Disconnect the M30 rear combination light assembly LH connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Rear Combination Light Assembly LH)

Measure the voltage according to the value(s) in the table below.

Standard Voltage

Tester Connection	Condition	Specified Condition
M30-2 (STP) - M30-6 (E)	Brake pedal released	Below 1 V
M30-2 (STP) - M30-6 (E)	Brake pedal depressed	11 to 14 V
M30-4 (B) - M30-6 (E)	Turn signal switch in neutral position	Below 1 V
M30-4 (B) - M30-6 (E)	Power switch ON, turn signal switch in left turn position	11 to 14 V (60 to 120 times per minute)
M30-3 (TL) - M30-6 (E)	Light control switch off	Below 1 V
M30-3 (TL) - M30-6 (E)	Light control switch in tail position	11 to 14 V

If the result is not as specified, repair or replace wire harness or connector.

INSPECT REAR COMBINATION LIGHT ASSEMBLY RH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Rear Combination Light Assembly RH)

Disconnect the M32 rear combination light assembly RH connector.

Measure the voltage according to the value(s) in the table below.

Standard Voltage

Tester Connection	Condition	Specified Condition
M32-2 (STP) - M32-6 (E)	Brake pedal released	Below 1 V
M32-2 (STP) - M32-6 (E)	Brake pedal depressed	11 to 14 V
M32-4 (B) - M32-6 (E)	Turn signal switch in neutral position	Below 1 V
M32-4 (B) - M32-6 (E)	Power switch ON, turn signal switch in right turn position	11 to 14 V (60 to 120 times per minute)
M32-3 (TL) - M32-6 (E)	Light control switch off	Below 1 V
M32-3 (TL) - M32-6 (E)	Light control switch in tail position	11 to 14 V

If the result is not as specified, repair or replace wire harness or connector.