LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Combination Meter / Clock (Service Information) (Hybrid) >> Combination Meter >> Removal [02/2014 - ] >> Procedure

Removal [02/2014 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [02/2014 - 11/2016] Refer to PRECAUTION [11/2016 - ]

  2. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 1 Refer to PROCEDURE - Step 1 Refer to PROCEDURE - Step 1

  3. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2 Refer to PROCEDURE - Step 2 Refer to PROCEDURE - Step 2

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [02/2014 - 11/2016] Refer to INITIALIZATION [11/2016 - ]

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 
    1. Disengage the 4 clips and 2 guides as shown in the illustration.
      GTY423616Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 9 claws and 2 guides and remove the instrument cluster finish panel assembly as shown in the illustration.
      GTY423618Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 2 screws.
      GTY450335Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 clips as shown in the illustration.
      GTY423517Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the 2 connectors to remove the combination meter assembly.
scientia non olet · About LEMON Manuals