DCM Power Source Circuit [02/2014 - ]: Procedure

1. Disconnect the F35 DCM (Telematics Transceiver) connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to DCM (Telematics Transceiver))

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F35-4 (E) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F35-1 (+B) - F35-4 (E)	Power switch off	11 to 14 V
   F35-7 (IG2) - F35-4 (E)	Power switch on (IG)	11 to 14 V
   F35-8 (ACC) - F35-4 (E)	Power switch on (ACC)	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [02/2014 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR