DTC C1AA1: FCM Destination Information Unmatched [02/2014 - 11/2016]: Procedure
- READ VALUE USING TECHSTREAM (DESTINATION INFORMATION)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Chassis / Lane Departure Alert / Data List.
- Read the Data List according to the display on the Techstream.
Chassis > Lane Departure Alert > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Destination Information Status of the country JPN, NA, EURO, CHINA or OTHER Actual country code - Chassis > Lane Departure Alert > Data List
Tester Display Destination Information Result
Result Proceed to Country specification information for vehicle and lane departure warning camera match A Country specification information for vehicle and lane departure warning camera do not match B
Result: 2
B
REPLACE LANE DEPARTURE WARNING CAMERA. Refer to REMOVAL [02/2014 - 11/2016]
Result: 1
A
See step 2
- CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM)
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [02/2014 - 11/2016]
Chassis > Lane Departure Alert > Clear DTCs
- Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
- Check for DTCs.
Refer to DTC CHECK / CLEAR [02/2014 - 11/2016]
Chassis > Lane Departure Alert > Trouble Codes
Result
Result Proceed to DTC C1AA1 is not output A DTC C1AA1 is output B
Result: 1
A
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2014 - 11/2016]
Result: 2
B
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to REMOVAL [02/2014 - 11/2016]
- Clear the DTCs.