Indicator Circuit [02/2014 - 11/2016]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Perform Active Test according to the display on the Techstream.

   Body Electrical > Combination Meter > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   LDA Control Indicator	Lane departure alert indicator	OFF or ON	w/ Multi-information Display (LCD Display Type) Confirm that the vehicle is stopped with the power switch on (IG)
   Meter Display 1	Multi-information display	OFF or All	w/ Multi-information Display (TFT Display Type) Confirm that the vehicle is stopped with the power switch on (IG)

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   LDA Control Indicator

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Meter Display 1

   OK

   The multi-information display turns on or off.

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

GO TO METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [02/2014 - ] 

Result:  1

OK 

See step  2

1. Enter the following menus: Chassis / Lane Departure Alert / Data List.
2. Read the Data List according to the display on the Techstream.

   Chassis > Lane Departure Alert > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   LDA Indicator	Status of the lane departure alert indicator	Nothing or Green	Nothing: Lane departure alert indicator not displayed Green: Lane departure alert indicator displayed	-

   Chassis > Lane Departure Alert > Data List 

   Tester Display
   LDA Indicator

   OK

   When the lane departure alert main switch is operated, the display changes as shown above.

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [02/2014 - 11/2016] 

Result:  3

NG 

REPLACE LANE DEPARTURE WARNING CAMERA. Refer to  REMOVAL [02/2014 - 11/2016]