Reassembly [08/2013 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the fuel pump.

Refer to INITIALIZATION [08/2013 - 08/2016] Refer to INITIALIZATION [08/2016 - ]

1. Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	O-ring
   *2	Fuel Pump Spacer

2. Connect the fuel pump harness connector.
3. Engage the 5 claws to install the fuel pump.
   NOTE:

   • Do not remove the suction filter.
   • Do not use either the fuel pump or suction filter if the suction filter is removed from the fuel pump.
4. Engage the 2 claws of the No. 1 fuel suction support to the fuel filter.
5. Connect the fuel pump harness connector.
6. Install the spring to the fuel suction plate shaft.
7. Engage the 2 claws of the No. 1 fuel suction support and install the fuel filter and fuel pump onto the fuel sub-tank.
8. Install a new E-ring to the fuel suction plate shaft.
9. Engage the claw and install the fuel pump filter hose while aligning it with the installation position of the fuel sub-tank.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Do not apply excessive force to the fuel pump filter hose or No. 1 fuel suction support.

See step  1