Inspection [08/2013 - 08/2016]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Transmission Wire)Standard Resistance
Tester Connection Condition Specified Condition 1 (THO) - 6 (E2) Always 79 Ω to 156 kΩ 1 (THO) - Body ground Always 10 kΩ or higher 6 (E2) - Body ground Always 10 kΩ or higher HINT:
If the resistance is out of the specified range with the ATF temperature shown in the table below, the driveability of the vehicle may decrease.
ATF Temperature Specified Condition 10°C (50°F) 5 to 8 kΩ 25°C (77°F) 2.5 to 4.5 kΩ 110°C (230°F) 0.22 to 0.28 kΩ If the resistance value is not as specified, replace the transmission wire.
- Measure the resistance according to the value(s) in the table below.