On-Vehicle Inspection [08/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
1. Apply the parking brake and turn the ignition switch to ON.
2. Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start in any other position.
3. Check that the back-up light illuminates and the reverse warning buzzer sounds only when the shift lever is in R, but does not function in any other position.
  If a malfunction or failure is found, check the park/neutral position switch assembly for continuity.