LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Corolla S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Continuously Variable Transaxle - Diagnostic Codes (3 Of 3) & Circuit Tests (Model Code: ZRE172)) >> Continuously Variable Transaxle System >> DTC P0717, P07BF, P07C0; Input/Turbine Speed Sensor "A" Circuit No Signal [08/2016 - 08/2017] >> Description

DTC P0717, P07BF, P07C0; Input/Turbine Speed Sensor "A" Circuit No Signal [08/2016 - 08/2017]: Description

WARNING: This page is about a different variant/trim than selected.

The ECM receives a signal from the revolution sensor (transmission revolution sensor (NT)) installed in the continuously variable transaxle to control the lock-up engagement pressure and forward and reverse clutch pressure.

The transmission revolution sensor (NT) detects the continuously variable transaxle input shaft speed and sends a signal to the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0717 Input/Turbine Speed Sensor "A" Circuit No Signal
  1. Diagnosis Condition
    • The vehicle is driven with the shift lever in D, the output shaft speed is 300 rpm or more, and no error is detected in the park/neutral position switch assembly.
  2. Malfunction Status
    • The speed indicated by the transmission revolution sensor (NT) is less than 300 rpm.
  3. Malfunction Time
    • 2 seconds
  4. Other
    • 1-trip detection logic
  • Wire harness or connector
  • Continuously variable transaxle assembly (Transmission revolution sensor (NT))
  • ECM
 Comes on DTC stored
P07BF Input/Turbine Speed Sensor "A" Circuit Low
  1. Diagnosis Condition
    • A transmission revolution sensor (NT) signal malfunction is not detected.
  2. Malfunction Status
    • The transmission revolution sensor (NT) output voltage is less than 0.2 V.
  3. Malfunction Time
    • 2 seconds
  4. Other
    • 1-trip detection logic
  • Wire harness or connector
  • Continuously variable transaxle assembly (Transmission revolution sensor (NT))
  • ECM
 Comes on DTC stored
P07C0 Input/Turbine Speed Sensor "A" Circuit High
  1. Diagnosis Condition
    • A transmission revolution sensor (NT) signal malfunction is not detected.
  2. Malfunction Status
    • The transmission revolution sensor (NT) output voltage is higher than 1.8 V.
  3. Malfunction Time
    • 2 seconds
  4. Other
    • 1-trip detection logic
  • Wire harness or connector
  • Continuously variable transaxle assembly (Transmission revolution sensor (NT))
  • ECM
 Comes on DTC stored
scientia non olet · About LEMON Manuals