LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Corolla S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical (2ZR-FAE) - Service Information (1 Of 2) (Model Code: ZRE172)) >> Drive Belt >> On-Vehicle Inspection [08/2013 - ] >> Procedure

On-Vehicle Inspection [08/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT V-RIBBED BELT 
    1. Check the V-ribbed belt for wear, cracks or other signs of damage.

      If any of the following defects is found, replace the V-ribbed belt:

      GTY135234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • The V-ribbed belt is cracked.
      • The V-ribbed belt is worn out to the extent that the cords are exposed.
      • The V-ribbed belt has chunks missing from the ribs.
    2. Check that the V-ribbed belt fits properly in the ribbed grooves.
      GTY444726Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Correct
      *b Incorrect

      HINT: 

      Check with your hand to confirm that the V-ribbed belt has not slipped out of the groove on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.

scientia non olet · About LEMON Manuals