Inspection [08/2013 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT ENGINE SWITCH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition 5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher 1 (SS2) - 6 (AGND) 5 (SS1) - 6 (AGND) Pushed Below 1 Ω 1 (SS2) - 6 (AGND) If the result is not as specified, replace the engine switch.
- Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch indicator light.NOTE:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
- If the voltage is too low, the engine switch indicator light will not illuminate.
Standard
Condition Specified Condition Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)Illuminates *a Indicator Light - - If the result is not as specified, replace the engine switch.
- Measure the resistance according to the value(s) in the table below.