LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Corolla S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Lubrication System (2ZR-FAE) (Service Information) (Model Code: ZRE172)) >> Oil Pump >> Reassembly [08/2013 - ] >> Procedure

Reassembly [08/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL OIL PUMP RELIEF VALVE 
    1. Coat the oil pump relief valve and oil pump relief valve hole with engine oil.
      GTY443248Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Oil Pump Relief Valve
      *2 Oil Pump Relief Valve Spring
      *3 Oil Pump Relief Valve Plug
    2. Insert the oil pump relief valve and oil pump relief valve spring into the oil pump body hole.
    3. Using a 22 mm socket wrench, install the oil pump relief valve plug.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

  2. INSTALL OIL PUMP ROTOR SET 
    1. Coat the oil pump drive rotor and oil pump driven rotor with engine oil, and place them into the oil pump body with the marks facing the oil pump cover sub-assembly side.
      GTY449498Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Mark
  3. INSTALL OIL PUMP COVER SUB-ASSEMBLY 
    1. Install the oil pump cover sub-assembly with the 6 bolts.
      GTY426118Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf) 

scientia non olet · About LEMON Manuals