LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Corolla S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Lubrication System (2ZR-FAE) (Service Information) (Model Code: ZRE172)) >> Oil Pressure Switch >> Removal [08/2013 - ] >> Procedure

Removal [08/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disconnect the engine oil pressure switch assembly connector.
    2. Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.
      GTY217824Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals