Inspection Procedure
NOTE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work. Refer to PRECAUTION [08/2015 - ] .
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
HINT:
When DTC B1650/32 is detected as a result of troubleshooting for the airbag system, check for DTCs stored in the occupant detection ECU. When DTC B1794 is output, perform troubleshooting for the DTC.