DTC P2769: Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL); DTC P2770: Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL) [08/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL)
- Remove the TCM from the transaxle.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 6 (SL) - Body ground 20°C (68°F) 11 to 15 Ω TEXT IN ILLUSTRATION*a Component without harness connected
(Transmission Wire)
NG → See step 2
OK → See step 3
- Remove the TCM from the transaxle.
- INSPECT SHIFT SOLENOID VALVE SL
- Remove shift solenoid valve SL.TEXT IN ILLUSTRATION
*1 Shift Solenoid Valve SL - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Solenoid Connector (SL) - Solenoid Body (SL) 20°C (68°F) 11 to 15 Ω Result
Result Proceed to OK A NG (When not using the engine support bridge) B NG (When using the engine support bridge) C
B → See step 5
C → See step 6
A → See step 4
- Remove shift solenoid valve SL.
- REPLACE TCM. Refer to COMPONENTS [08/2015 - ]
- REPLACE TRANSMISSION WIRE. Refer to COMPONENTS [08/2015 - ]
- REPLACE SHIFT SOLENOID VALVE SL. Refer to COMPONENTS [08/2015 - ]
- REPLACE SHIFT SOLENOID VALVE SL. Refer to COMPONENTS [08/2015 - ]