DTC C1582: Assist Map Number Mismatch [08/2015 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
1. Using the Techstream, check for DTCs and confirm that there are no problems in the CAN communication system. Refer to DIAGNOSIS SYSTEM [08/2015 - ] .
  OK
  
  DTC is not output.
NG → See step 5

OK: Go to next step
CHECK ECM
1. Check if the correct ECM is installed.
  OK
  
  The correct ECM is installed.
NG → See step 6

OK: Go to next step
CHECK BRAKE ACTUATOR ASSEMBLY
1. Check if the correct brake actuator assembly is installed.
  OK
  
  The correct brake actuator assembly is installed.
NG → See step 7

OK → See step 4
REPLACE POWER STEERING ECU ASSEMBLY. Refer to REMOVAL [08/2015 - ]
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
REPLACE ECM. Refer to REMOVAL [08/2015 - ]
REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to REMOVAL [08/2015 - ]