Remote Engine Starter does not Operate [08/2015 - ]: Description

When the remote engine starter ECU receives wireless signals via BERKES and CAN communication line, the remote engine starter ECU transmits the signals to each ECU through the main body ECU (multiplex network body ECU) via the CAN communication line, and starts or stops the engine.

HINT: 

If all of the following conditions are met, the engine starts using the remote engine start function:

• The shift lever is in P.
• All doors are closed.
• All doors are locked.
• The engine hood is closed.
• The engine switch is off.
• The engine switch is not pressed.
• The engine speed is not input.
• Vehicle speed is not input.
• Brake pedal is not depressed.
• The theft deterrent system is not alarm sounding state.

The engine will stop when any of the following conditions is met:

• 10 minutes elapse after the engine is started.
• The shift lever is moved from P.
• Any door is opened.
• Any door is unlocked.
• The engine hood is opened.
• The engine switch is turned on (ACC or IG).
• The engine speed is kept less than 200 rpm for 40 seconds.
• The engine speed is kept more than 3000 rpm for 3 seconds.
• Vehicle speed is input (more than 5 km/h (3 mph)).
• Brake pedal is depressed.
• The theft deterrent system is alarm sounding state.