Inspection Procedure
NOTE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- Before performing the inspection, check that DTC U0142 is not output.
- Before replacing the remote engine starter ECU, refer to Registration of the remote engine starter system. Refer to REGISTRATION [08/2015 - ] .
- Before replacing the certification ECU (smart key ECU assembly), refer to Registration of the engine immobiliser system. Refer to REGISTRATION [08/2015 - ] .
- The remote engine starter system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] . Troubleshoot the remote engine starter system after confirming that the communication systems are functioning properly.