DTC C1AB7: Blind Spot Monitor Slave Module [08/2015 - ]: Procedure

CHECK DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ] .
2. Recheck for DTCs and check if the same DTC is output again.
  OK
  
  No DTCs are output.
NG → See step 3

OK → See step 2
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
REPLACE BLIND SPOT MONITOR SENSOR LH. Refer to REMOVAL [08/2015 - ]