DTC C1A45: Vehicle Speed Sensor [08/2015 - ]: Procedure

1. Check for DTCs of the vehicle stability control system. Refer to DTC CHECK / CLEAR [08/2015 - ] .

   OK

   Vehicle stability control system DTCs are not output.

NG → See step   3 

OK: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ] .
2. Recheck for DTCs and check if the same DTC is output again.

   Result

   Result	Proceed to
   No DTCs are output	A
   DTC is output from the blind spot monitor sensor RH (Master)	B
   DTC is output from the blind spot monitor sensor LH (Slave)	C

B → See step   5 

C → See step   6 

A → See step   4