DTC B2795: Unmatched Key Code [08/2015 - ]: Procedure

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ] .

NEXT: Go to next step 

1. Perform "DTC Output Confirmation Operation" procedure.
2. Check for DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ] .

   HINT: 

   If DTC B2795 is stored, check for DTCs with the next door control transmitter assembly after clearing the DTCs.

   OK

   DTC B2795 is not output.

   Result

   Result	Proceed to
   DTC B2795 is output for any of the door control transmitter assemblies	A
   DTC B2795 is output for all of the door control transmitter assemblies	B
   DTC B2795 is not output	C

B → See step   6 

C → See step   5 

A: Go to next step 

1. Check that the ignition switch can be turned to ON using the door control transmitter assembly for which the DTC was stored.

   OK

   Ignition switch can be turned to ON using the door control transmitter assembly (for which the DTC was stored).

NG → REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY THAT DTC IS OUTPUT 

OK: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ] .
2. Register the key ID code with the transponder key ECU assembly. Refer to REGISTRATION [08/2015 - ] .

   OK

   Registration procedure can be completed.

NG → REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY THAT DTC IS OUTPUT 

OK → END (DOOR CONTROL TRANSMITTER ASSEMBLY REGISTRATION FAILURE)