LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Avalon XLE >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belts (Service Information) (Except Hybrid) >> Rear Seat Outer Belt Assembly >> Removal [10/2014 - ] >> Procedure

Removal [10/2014 - ]: Procedure

  1. REMOVE REAR SEAT ASSEMBLY 

    (Refer to REMOVAL [10/2014 - ] )

  2. REMOVE REAR DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 8 or PROCEDURE - Step 8

  3. REMOVE REAR DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

  4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH 
    1. Disconnect the rear door opening trim weatherstrip LH.
  5. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH 

    HINT: 

    Use the same procedure as for the LH side.

  6. REMOVE REAR SEAT SIDE GARNISH LH 

    Refer to PROCEDURE - Step 24 or PROCEDURE - Step 24

  7. REMOVE REAR SEAT SIDE GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

  8. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH 
    1. Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly LH.
      GTY375417Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  10. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH 

    See step  2

  11. DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH 

    See step  11

  12. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH 

    Refer to PROCEDURE - Step 25 or PROCEDURE - Step 25

  13. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  14. REMOVE REAR SEAT SHOULDER BELT HOLE COVER 
    1. Using a moulding remover, disengage the 2 claws and 2 guides and remove the rear seat shoulder belt hole cover.
      GTY375414Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the other 2 rear seat shoulder belt hole covers.

  15. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 
    GTY383504Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the connector.
    2. Disengage the 4 clips.
    3. Disengage the 5 guides.
    4. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
  16. REMOVE REAR SEAT OUTER BELT ASSEMBLY LH 
    GTY375430Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the bolt.
    2. Disengage the guide to remove the rear seat outer belt assembly LH.
  17. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

scientia non olet · About LEMON Manuals