Wireless Charger Illumination Circuit [10/2014 - ]: Procedure

1. Disconnect the D118 upper console panel sub-assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   D118-9 (TAIL) - Body ground	Light control switch in tail or head position	11 to 14 V

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [10/2014 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR