Red Indicator Remains On [10/2014 - ]: Procedure

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG) and wait for 10 seconds.
4. Turn the Techstream on.
5. Perform "Health Check" and check for current DTCs (Refer to HEALTH CHECK [10/2014 - ] ).

   Result

   Result	Proceed to
   DTC is not output.	A
   DTC is output.	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2014 - ] )

Result: 

A 

See step  2

1. Replace the DCM (Telematics Transceiver) (Refer to REMOVAL [10/2014 - ] ).
   NOTE:

   • The engine switch must be off.
   • Do not replace the DCM (Telematics Transceiver) with one from another vehicle.

Result: 

NEXT 

See step  3

1. Perform "PRL UPDATE" (Refer to PRL UPDATE [10/2014 - ] ).

Result: 

NEXT 

PERFORM DCM ACTIVATION 

(Refer to DCM ACTIVATION [10/2014 - ] )