DTC B1583: GPS Signal Unreceived [10/2014 - ]: Procedure

1. Check that there are no problems with the telephone and GPS antenna assembly.

   OK

   The antenna is not excessively dirty, and there are no objects blocking signal reception.

Result: 

NG 

REMOVE FOREIGN MATTER 

Result: 

OK 

See step  2

1. Replace the telephone and GPS antenna assembly (Refer to REMOVAL [10/2014 - ] ).

Result: 

NEXT 

See step  3

1. Clear the current and historic DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).

Result: 

NEXT 

See step  4

1. Drive the vehicle for at least 15 miles, manual (SOS) switch red indicator will illuminate at approximately 10 miles if problem still exists.
2. Turn the engine switch off.
3. Connect the Techstream to the DLC3.
4. Turn the engine switch on (IG) and wait for 10 seconds.
5. Turn the Techstream on.
6. Perform "Health Check" and check current and historic DTC (Refer to HEALTH CHECK [10/2014 - ] ).

   HINT: 

   Basically turning engine switch off will clear the current DTC until vehicle is driven about 10 miles again with the issue.

   Result

   Result	Proceed to
   DTC B1583 is output.	A
   DTC B1583 is not output.	B

Result: 

B 

END 

Result: 

A 

See step  5

1. Replace the DCM (Telematics Transceiver) (Refer to REMOVAL [10/2014 - ] ).
   NOTE:

   • The engine switch must be off.
   • Do not replace the DCM (Telematics Transceiver) with one from another vehicle.

Result: 

NEXT 

See step  6

1. Perform "PRL UPDATE" (Refer to PRL UPDATE [10/2014 - ] ).

Result: 

NEXT 

PERFORM DCM ACTIVATION 

(Refer to DCM ACTIVATION [10/2014 - ] )