| Skid Control ECU Communication Stop Mode |
Either condition is met:
- "Skid Control (ABS/VSC/TRAC) " is not displayed on the CAN Bus Check screen of the Techstream (Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ]
)
- Communication system DTCs (DTCs that start with U) that correspond to "Skid Control ECU Communication Stop Mode" in "DTC Combination Table" are output (Refer to DIAGNOSIS SYSTEM [10/2015 - ]
)
|
- Skid control ECU (brake actuator assembly) branch line or connector
- Power source circuit of skid control ECU (brake actuator assembly)
- Skid control ECU (brake actuator assembly) ground circuit
- Skid control ECU (brake actuator assembly)
|