Typical Enabling Conditions
| Engine | Running |
| Intermediate shaft speed sensor revolution (Counter gear revolution) | 300 rpm or more |
| Battery voltage | 8 V or more |
| Engine switch | on (IG) |
| Starter | OFF |
| Either a or b is met (See below) | |
| a. All of the following conditions are met | |
| ECT | 20°C (68°F) or more |
| ECT sensor circuit fail (P0115, P0117, P0118, P0125) (Pending + MIL) |
Not detected |
| Time after PNP switch ON to OFF | 2 sec. or more |
| b. All of the following conditions are met | |
| Either of the following conditions is met: 1. or 2. | |
| 1. ECT | Less than 20°C (68°F) |
| 2. ECT sensor circuit fail (P0115, P0117, P0118, P0125) (Pending + MIL) |
Detected |
| Time after PNP switch ON to OFF | 30 sec. or more |