LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Avalon XLE Plus >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension (Service Information) (Except Hybrid) >> Rear Stabilizer Bar >> Inspection [10/2014 - ] >> Procedure

Inspection [10/2014 - ]: Procedure

  1. INSPECT REAR STABILIZER LINK ASSEMBLY 
    1. Inspect the turning torque of the ball joint.
      GTY163602Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
      1. Secure the rear stabilizer link assembly in a vise using aluminum plates.
      2. Install the nut to the rear stabilizer link assembly stud.
      3. Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

        Turning Torque

        0.05 to 0.98 N*m (0.6 to 9.9 kgf*cm, 0.5 to 8.6 in.*lbf)

        If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.

    2. Inspect the dust cover.
      1. Check that the dust cover is not cracked and that there is no grease on it.

        If there are any abnormalities, replace the rear stabilizer link assembly with a new one.

scientia non olet · About LEMON Manuals