Removal [10/2014 - ]: Procedure
- RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
See step 1
- REMOVE RADIATOR ASSEMBLY
(Refer to REMOVAL [10/2014 - ] )
- REMOVE V-RIBBED BELT
(Refer to REMOVAL [10/2014 - ] )
- DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
- Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor and magnetic clutch.
- Remove the O-ring from the No. 1 cooler refrigerant discharge hose.NOTE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
- Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor and magnetic clutch.
- DISCONNECT SUCTION HOSE SUB-ASSEMBLY
- REMOVE COMPRESSOR AND MAGNETIC CLUTCH