How To Proceed With Troubleshooting [10/2014 - 10/2015]: Procedure

Result

Result: 

NEXT 

See step  2

1. Interview the customer to confirm the trouble (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] ).

Result: 

NEXT 

See step  3

1. Measure the battery voltage.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result: 

NEXT 

See step  4

1. Using the Techstream, check if the CAN communication system is functioning normally (Refer to DIAGNOSIS SYSTEM [10/2014 - 10/2015] ).

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] )

Result: 

A 

See step  5

1. Clear DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
2. Check for DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO AIRBAG SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] )

Result: 

A 

See step  6

1. Clear DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
2. Check for DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO OCCUPANT CLASSIFICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] )

Result: 

A 

See step  7

1. Check the operation of the speedometer, shift indicator and brake warning light on the combination meter assembly.

   OK

   The speedometer, shift indicator and brake warning light on the combination meter assembly operate normally.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO METER / GAUGE SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] )

Result: 

OK 

See step  8

1. Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [10/2014 - ] ).

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

Result: 

B 

See step  10

Result: 

A 

See step  9

1. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [10/2014 - ] )
2. Terminals of ECU (Refer to TERMINALS OF ECU [10/2014 - ] )
3. On-vehicle Inspection (Refer to ON-VEHICLE INSPECTION [10/2014 - ] )

Result: 

NEXT 

See step  10

Result: 

NEXT 

See step  11

Result: 

NEXT 

END