DTC C1442: Invalid Data Received from Deceleration Sensor; DTC C1443: Invalid Data Received from Yaw Rate Sensor [08/2019 - ]: Procedure
- CHECK DTC
- Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2019 - ] ).
- Turn the ignition switch off.
- Start the engine and idle it for 60 seconds, and then stop the engine.
- Check if the same DTC is output (Refer to DTC CHECK / CLEAR [08/2019 - ]
).RESULT
Result Proceed to DTCs C1442 and/or C1443 are output A DTCs C1442 and C1443 are not output B
Result:
A
REPLACE AIR BAG SENSOR ASSEMBLY. Refer to REMOVAL [08/2015 - ]
Result:
B
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ]