LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> 4Runner TRD Pro >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge System - Diagnostics - Introduction (2 Of 2) >> Meter / Gauge System >> Terminals Of Ecu [08/2019 - ] >> Terminals Of Ecu [08/2019 - ]

Terminals Of Ecu [08/2019 - ]

  1. COMBINATION METER ASSEMBLY 
    Fig 1: Combination Meter Assembly Connector End View
    GTY878829Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the voltage and resistance and check for pulses according to the value(s) in the table below.
      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      F14-1 (E2) - Body ground LG - Body ground Light control rheostat switch ground Ignition switch ON, RH turn indicator light off Below 1 Ω
      F14-4 (LINT) - Body ground*1 L - Body ground LIN (Drive monitor switch communication) Always Below 1 Ω
      F14-7 (HZSW) - Body ground GR - Body ground Hazard warning switch signal Hazard warning signal switch assembly off 11 to 14 V
      Hazard warning signal switch assembly on Below 1 V
      F14-12 (CHG-) - Body ground SB - Body ground Charge warning light signal Ignition switch ON, charge warning light off 11 to 14 V
      Ignition switch ON, charge warning light on Below 1 V
      F14-16 (SW) - Body ground*2 P - Body ground Brake fluid level warning switch signal Ignition switch ON, brake fluid level warning light on Below 1 V
      Ignition switch ON, brake fluid level warning light off 11 to 14 V
      F14-17 (+S) - Body ground GR - Body ground Speed signal for other systems (Output) Driving at approx. 20 km/h (12 mph) Pulse generation
      (See waveform 1)
      F14-18 (SI) - Body ground V - Body ground Speed signal for other systems (Input) Driving at approx. 20 km/h (12 mph) Pulse generation
      (See waveform 1)
      F14-20 (MGND) - Body ground W-B - Body ground Ground (Signal ground) Always Below 1 Ω
      F14-21 (B) - Body ground V - Body ground Battery Always 11 to 14 V
      F14-22 (IG+) - Body ground R - Body ground Ignition switch signal Ignition switch off Below 1 V
      Ignition switch ON 11 to 14 V
      F14-26 (L) - F14-2 (E3) LG - GR Fuel level signal Ignition switch ON, fuel level full → low (fuel level warning light on) Pulse generation
      (See waveform 2)
      F14-27 (STP+) - Body ground*3 G - Body ground Automatic Running Boards warning light signal Automatic Running Boards warning light on or blinking 11 to 14 V
      Automatic Running Boards warning light off Below 1 V
      F14-28 (STPA) - Body ground*3 W - Body ground Ground Automatic Running Boards warning light off 11 to 14 V
      Ignition switch ON, automatic running boards warning light on Below 1 V
      F14-28 (STPA) - Body ground*4 W - Body ground Ground Always Below 1 Ω
      F14-30 (WLVL) - Body ground*5 W - Body ground Washer level warning switch signal Ignition switch ON, washer level warning light off 11 to 14 V
      Ignition switch ON, washer level warning light on Below 1 V
      F14-31 (MSM+) - Body ground LG - Body ground Steering pad switch assembly signal Ignition switch ON, OK and back switches on steering pad switch assembly not pushed 4.6 to 5.4 V
      F14-32 (MSTI) - Body ground L - Body ground Steering pad switch assembly signal Ignition switch ON, up, down, right and left switches on steering pad switch assembly not pushed 4.6 to 5.4 V
      F14-33 (RHIG) - Body ground B - Body ground Power source for light control rheostat Ignition switch ON 4.6 to 5.4 V
      F14-34 (TR) - Body ground GR - Body ground Light control rheostat signal Light control rheostat dial fully turned downward Below 1 Ω
      Light control rheostat dial fully turned upward 8 to 12 kΩ
      F14-35 (TC) - Body ground W - Body ground TAIL cancel switch signal TAIL cancel switch off 1 MΩ or higher
      TAIL cancel switch on Below 1 Ω
      F14-36 (INT) - Body ground SB - Body ground Electrical key and tire pressure monitoring system receiver assembly signal Ignition switch ON, OK switch on steering pad switch not pushed 8 to 15 V
      F14-37 (MSCL) W CAN communication line - -
      F14-38 (MSCH) G CAN communication line - -
      F14-39 (CANL) W CAN communication line - -
      F14-40 (CANH) V CAN communication line - -
      F109-1 (B) - Body ground P - Body ground Battery Always 11 to 14 V
      F109-2 (E1) - Body ground W-B - Body ground Ground Always Below 1 Ω
      F109-4 (ER) - Body ground P - Body ground RH turn indicator light signal (Input) Ignition switch ON, RH turn signal switch off 11 to 14 V
      Ignition switch ON, RH turn signal switch on Below 1 Ω
      F109-5 (EL) - Body ground L - Body ground LH turn indicator light signal (Input) Ignition switch ON, LH turn signal switch off 11 to 14 V
      Ignition switch ON, LH turn signal switch on Below 1 Ω
      F109-6 (S) - Body ground V - Body ground Oil pressure switch signal Ignition switch ON, oil pressure warning light off 11 to 14 V
      Ignition switch ON, oil pressure warning light on Below 1 V
      F109-8 (LL) - Body ground Y - Body ground LH turn indicator light signal (Output) Ignition switch ON, LH turn indicator light off Below 1 Ω
      Ignition switch ON, LH turn indicator light blinking 11 to 14 V ←→ Below 1 V
      F109-9 (ILL-) - Body ground GR - Body ground Illumination signal Light control switch off Below 1 V
      Light control switch in tail or head position Pulse generation
      F109-10 (IL2-) - Body ground W - Body ground Illumination signal Light control switch off Below 1 V
      Light control switch in tail or head position Pulse generation
      F109-13 (LR) - Body ground B - Body ground RH turn indicator light signal (Output) Ignition switch ON, RH turn indicator light off Below 1 Ω
      Ignition switch ON, RH turn indicator light blinking 11 to 14 V ←→ Below 1 V
      1. *1: w/ CRAWL Control
      2. *2: for 2WD
      3. *3: w/ Automatic Running Board System
      4. *4: w/o Automatic Running Board System
      5. *5 w/ Level Warning Switch Assembly
    2. Using an oscilloscope, check waveform 1.
      Fig 2: Waveform 1
      GTY927711Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      WAVEFORM 1 (REFERENCE)

      Item Condition
      Tool setting 5 V/DIV., 20 ms./DIV.
      Vehicle condition Driving at approx. 20 km/h (12 mph)

      HINT: 

      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

    3. Using an oscilloscope, check waveform 2.
      Fig 3: Waveform 2
      GTY937611Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      WAVEFORM 2 (REFERENCE)

      Item Condition
      Tool setting 5 V/DIV., 20 ms/DIV.
      Vehicle condition Ignition switch ON, fuel level full → low (fuel level warning light on)

      HINT: 

      (A) will depending on the fuel level.

      • Fuel level full: Below 4 V
      • Fuel level low (fuel level warning light on): 4 to 9 V
  2. ACCESSORY METER ASSEMBLY 
    Fig 4: Accessory Meter Assembly Connector End View
    GTY696250Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the voltage and resistance according to the value(s) in the table below.
      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      G36-1 (B) - Body ground GR - Body ground Battery Always 11 to 14 V
      G36-2 (ACC) - Body ground R - Body ground Ignition switch signal Ignition switch off Below 1 V
      Ignition switch ACC 11 to 14 V
      G36-3 (ILL+) - Body ground B - Body ground Illumination signal Light control switch in tail or head position 11 to 14 V
      G36-7 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω
scientia non olet · About LEMON Manuals