Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| The monitor will run whenever the following DTCs are not stored | None |
| Solenoid current cut status | Not cut |
| Ignition switch | ON |
| Starter | OFF |
CONDITION (A)
| One of following conditions is met | Condition (1), (2) or (3) |
| Condition (1): Battery voltage | 12 V or higher |
| Condition (2) | - |
| - Battery voltage | 10 V or higher, and below 12 V |
| - Target current | Below 0.75 A |
| Condition (3) | - |
| - Battery voltage | 8 V or higher |
| - Target current | 0.25 A or higher |
CONDITION (B)
| Battery voltage | 11 V or higher |
| Target current | 1 A or higher |
CONDITION (C)
| Battery voltage | 11 V or higher |
| Target current | 0.1 A or higher |
| Difference between target voltage and last target voltage | Little to no difference |