Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
[OFF malfunction]
- All of the following are met: OFF malfunction (A), (B), (C) and (D)
2 detections are necessary per driving cycle:
1st detection: Temporary flag ON
2nd detection: Pending fault code ON
OFF MALFUNCTION (A) AND (B)
| Turbine speed/Output speed (NT/NO) | 3.30 or more, and 7.50 or less (This means actual gear is 1st) |
OFF MALFUNCTION (C)
| Turbine speed/Output speed (NT/NO) | 0.65 or more, and 0.79 or less (This means actual gear is 5th) |
OFF MALFUNCTION (D)
| Output record of ECM from 4th to 5th up-shift | Recorded |
[ON malfunction]
- Both of the following conditions are met:
ON malfunction (A) or (B), and ON malfunction (C) or (D)
ON MALFUNCTION (A)
| Turbine speed/Output speed (NT/NO) | 1.91 or more, and 2.35 or less (This means actual gear is 2nd) |
ON MALFUNCTION (B)
| Turbine speed/Output speed (NT/NO) | 1.28 or more, and 1.53 or less (This means actual gear is 3rd) |
ON MALFUNCTION (C)
| Turbine speed - Output speed x 4th gear ratio (NT - NO x 4th gear ratio) |
1000 rpm or more |
ON MALFUNCTION (D)
| Turbine speed - Output speed x 5th gear ratio (NT - NO x 5th gear ratio) |
1000 rpm or more |