Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| The monitor will run whenever the following DTCs are not stored | None |
| Solenoid current cut status | Not cut |
| Ignition switch | ON |
| Starter | OFF |
CONDITION (A)
| Battery voltage | 12 V or higher |
CONDITION (B)
| Battery voltage | 10 V or higher, and below 12 V |
| Target current | Below 0.75 A |
CONDITION (C)
| Battery voltage | 8 V or higher |
| Target current | 0.25 A or higher |