Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
[P0746 and P0771: OFF malfunction]
- All of the following conditions are met: OFF malfunction (A), (B) and (C)
- 2 detections are necessary per driving cycle
- 1st detection: temporary flag ON
- 2nd detection: pending fault code ON
OFF MALFUNCTION (A)
| Turbine speed/Output speed (NT/NO) | 0.93 or more, and 1.07 or less (This means actual gear is 4th) |
OFF MALFUNCTION (B)
| Turbine speed/Output speed (NT/NO) | Does not change as follows 0.93 or more, and 1.07 or less (This means actual gear is 4th) ↓ 0.65 or more, and 0.79 or less (This means actual gear is 5th) |
OFF MALFUNCTION (C)
| Output record of ECM from 4th to 5th up-shift | Recorded |
[P0771: ON malfunction]
- 2 detections are necessary per driving cycle
- 1st detection: temporary flag ON
- 2nd detection: pending fault code ON
ON MALFUNCTION
| Turbine speed - Output speed x 1st gear ratio (NT - NO x 1st gear ratio) |
150 rpm or more |