Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| The monitor will run whenever the following DTCs are not stored | P0705 (Park/neutral position switch circuit) P0746, P0748 (Shift solenoid valve SL1) P0776, P0778 (Shift solenoid valve SL2) P0751, P0973, P0974 (Shift solenoid valve S1) P0756, P0976, P0977 (Shift solenoid valve S2) |
| Shift change | Shift change is completed and before starting next shift change operation |
| ECM selected gear | 4th or 5th |
| Output shaft rpm | 1000 rpm or more |
| R switch | OFF |
| Engine | Running |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | OFF |