Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | OFF |
P0712: RANGE CHECK (LOW VOLTAGE)
| The monitor will run whenever this DTC is not stored | None |
P0713: Range Check (High Voltage)
- One of the following conditions is met: Condition (A) or (B)
- CONDITION (A)
The monitor will run whenever this DTC is not stored P0115, P0117, P0118 (ECT (Engine Coolant Temperature) sensor circuit)
P00AC, P00AD, P0110, P0112, P0113 (IAT (Intake Air Temperature) sensor circuit)Engine coolant temperature or intake air temperature at engine start -29.375°C (-20.875°F) or less Time after engine start 550 sec. or more
- CONDITION (B)
The monitor will run whenever this DTC is not stored P0115, P0117, P0118 (ECT (Engine Coolant Temperature) sensor circuit)
P00AC, P00AD, P0110, P0112, P0113 (IAT (Intake Air Temperature) sensor circuit)Engine coolant temperature or intake air temperature at engine start Higher than -29.375°C (-20.875°F) Time after engine start 10 sec. or more