DTC P0711: Transmission Fluid Temperature Sensor "A" Performance [08/2018 - 08/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK DTC OUTPUT (IN ADDITION TO DTC P0711)

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Read the DTCs using the Techstream.

RESULT

Result	Proceed to
Only P0711 is output	A
P0711 and other DTCs are output	B

HINT:

If any other codes besides P0711 are output, perform troubleshooting for those DTCs first.

Result:

B

GO TO DTC CHART

(Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - ] )

Result:

A

See step 2

CHECK TRANSMISSION FLUID LEVEL
1. Check the transmission fluid level (Refer to ADJUSTMENT [08/2015 - 08/2019] ).
  OK
  
  Automatic transmission fluid level is correct.
Result:

OK

REPAIR OR REPLACE NO. 1 ATF TEMPERATURE SENSOR (TRANSMISSION WIRE)

(Refer to REMOVAL [08/2015 - ] )

Result:

NG

ADD FLUID

(Refer to ADJUSTMENT [08/2015 - 08/2019] )